How do I set up Windows 95?

1. Click on the Start button in the lower left corner of the desktop toolbar.

2. Click on the Programs menu.

3. Click on the Accessories menu.

4. Click on the Dial-Up Networking option.

5. Double-Click on the Make New Connection icon.

6. In the “Type a name for the computer you are dialing:” box type: “RRT” {no quotes}

7. Click on the Next button

8. Enter in the phone number. Omit the area code. The number for your exchange is listed below

9. Click on the Next button.

10. Click on the Finish button.

11. Right click on your newly created ‘RRT’ icon.

12. Click on the Properties option.

13. Uncheck “Use country code and area code.”

14. Click on the Server Type button. [Note: in some versions of Windows 95 display this as a separate tab]

15. Make sure the “Type of Dial-Up Server” box starts with “PPP:Windows 95 …”

16. In the “Allowed Network Protocols” section, make sure only “TCP/IP” is checked.

17. Click on the TCP / IP Settings button.

18. If the circle is not checked next to “Server assigned IP address” click on the circle with the mouse to check it.

19. If the circle is not checked next to “Specify name server addresses” click on the circle with the mouse to check it.

20. In the box to the right of “Primary DNS” type: 206 .10 . 30 . 100

21. In the box to the right of “Secondary DNS” type: 206 .10. 30 . 101

22. Click on the OK button to close the window.

23. Click on the OK button to close the “Server Types” window.

24. Click on the OK button to close the remaining two windows.

25. Right click on the “The Internet” icon on the Windows 95 desktop.

26. Choose the Properties option.

27. Click on the “Connection” tab.

28. Click on the small white box to the left of “Connect to the Internet as needed.”

29. In the rectangular box below “Use the following dial-up connection” click on the small down arrow box and choose “RRT”

30. Click on the OK button.

Congratulations! You should be configured for our service.

Setting Up Internet Mail

1. Launch “Explorer” and click on the button Work Off-line.

2. From the “Go” menu select “Read Mail”

3. From the “Mail” menu select “Options”

4. Click on the “Server” tab at the top of the “Options” menu; then click Next.

5. Set “Incoming” and “Outgoing” to read : “rrt.net” [no quotes]

6. After the “Account Name” enter in your user name. Type in your password in the box below.

7. Click on the “Connection” tab. Check the circle next to “I use a modem to access my e-mail”

8. Select “RRT” as your connection.

9. Click the Apply button, then the OK button.